I have remote sites with legacy DN ranges that are disjointed. What is the most efficient method (with respect to call processing) of covering all DNs to a site? A single monolithic xlation pattern, or a series of more targeted and specific ranges? For example: DN range 3100 - 3199 & 3500 - 3700. Would 3XXX be better, or would 31xx & 3[5-7]xx be the more efficient?
It depends on wheater there is an overlap in the 3XXX range for other devices. If not this will be the most efficient since as soon as you dial 3X this pattern will be matched, and you only need one TP instead of 2. If there is a possible overlap in 3XXX range such as 3300, I would suggest going with the 2 TPs.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.