Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Eight-Class Model QoS for voice and video

One of the QoS recomendation in the SRND "Enterprise QoS" is to create a Eight-Class QoS Model utilizing a seperate priority queue for voice and video.

It says that even though you have only one physical priority queue, that LLQ has an implicit policer that allows for time-division multiplexing of the single priority queue. This implicit policer abstract the fact that there is essentially a single LLQ within the algorithm and, thus, allows for the "provisioning" of multiple LLQs.

My question is if anyone has tried this and if there are any limitations on the platforms that can support this "dual-LLQ design."

1 REPLY
Bronze

Re: Eight-Class Model QoS for voice and video

Design guide which is basically the QoSDesign recommendation bible.

http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdf

It has a large section for WAN recommendations...while you may not

need to follow one of these Based on my understanding what what you

have for a link (DS3) and what you are trying to accomplish, I

believe the following section would be a good place to start.

- WAN Aggregator QoS Design

- WAN Edge Classification and Provisioning Models

- High Link Speed QoS Class Model

- Eight-Class Model

247
Views
0
Helpful
1
Replies