Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Enable G.729 in CCME 3.3 and IP Phones

Hi

I need to know if it is possible and like configure CCME so that IP Phones work with G.729 like codec preferred

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Enable G.729 in CCME 3.3 and IP Phones

With CCME 3.3 you cannot do g729 codec. Phones can register only at g711. You can be part of a CME system and then send calls g729 over to another CCME system.

With CCME 4.0 there is support for remote teleworkers. YOu can enable g729 codec for phone as follows.

ephone 1

codec g729r8

HTH

Sankar

PS: please remember to rate posts!

1 REPLY

Re: Enable G.729 in CCME 3.3 and IP Phones

With CCME 3.3 you cannot do g729 codec. Phones can register only at g711. You can be part of a CME system and then send calls g729 over to another CCME system.

With CCME 4.0 there is support for remote teleworkers. YOu can enable g729 codec for phone as follows.

ephone 1

codec g729r8

HTH

Sankar

PS: please remember to rate posts!

103
Views
0
Helpful
1
Replies
CreatePlease login to create content