Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Enabling QSIG in C3745

Hello.

We have IP Trunks between an Avaya PBX and a Nortel PBX using Cisco 3745 Voice Gateways. For some reason the Voice Gateway reboot itself many times when Enabling QSIG. QSIG is not enabled right now so wwe don't have CIDs between PBX systems. Is there any way to have Caller ID display without enabling QSIG? Any suggestion?

Thanks,

Emamnuel

1 REPLY
Silver

Re: Enabling QSIG in C3745

If it is just Caller ID that you need, then regular PRI should work too.

What IOS are you running? This sounds like a bug since it crashes when enabling QSIG. You may want to do a bug search and try upgrading the IOS.

Regards,

Anup

108
Views
0
Helpful
1
Replies