Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Entering to Meet-me with password

Is it possible to password protect the meetme number? I mean joining users should enter a password.

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Entering to Meet-me with password

with only CUCM no, the WA is to have users join thru unity and have them announce themselves to accept or reject them.

if you do need pwd protection you'll need MPE

please search previous posts as this has been asked quite few times in the past

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2 REPLIES
Cisco Employee

Re: Entering to Meet-me with password

with only CUCM no, the WA is to have users join thru unity and have them announce themselves to accept or reject them.

if you do need pwd protection you'll need MPE

please search previous posts as this has been asked quite few times in the past

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Red

Re: Entering to Meet-me with password

Hi Okan,

Just to add a touch to the great tips from Java.

This solution (paraphrased) is presented in the Cisco Press book - Configuring Callmanager and Unity (A Step by Step Guide)

You can use a Unity Call Handler (with the same Extension as the Meet-Me DN)

Set up the Call Handler to do a Supervised Transfer to Ring the Meet-Me Conference.

Under the "Gather Caller Information" section of the Call Handler check "Confirm" and "Ask Callers Name"

When callers go through the Unity Call Handler they are asked to record their name, when the caller is forwarded to the Meet-Me Conference the name is played and conference participants are asked to Press 1 to accept the call or Press 2 to reject the call.

There is a nice discussion of this setup in this recent post (Thanks Deji and Robert);

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cbfa8c4

Hope this helps!

Rob

4223
Views
13
Helpful
2
Replies