12-16-2005 08:08 AM - edited 03-13-2019 11:34 AM
hello
using ccme and 7960G ephone, i think the default codec is G711 even if one ephone is in remote site!
is it possible to change the codec to g729 ?
12-16-2005 10:07 AM
You can set the codec on a per dial peer basis using the "codec" command in dial peer configuration mode. Please see the following link.
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_command_reference_chapter09186a00800b3504.html#wp1288993
Hope this helps.
Brandon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: