I was trying to set up "fast dial" for a new 7960 phone through "Cisco Personal Communications Assitant". Even though the "Communications Assistant" indicated "update successful", the phone always tells I need to configure the "IP Phone Services" first.
Have also tried from Call Manager Admin page. Still the same.
What could be the problem? Any suggestions? Thanks in advance.
Fast Dials are indeed an IP Phone Service. This service must be configured on CallManager. Go to: "Feature > Cisco IP Phone Services > Add a New IP Phone Service". Then, go to: "Help > For this page" to get further definitions of the fields that are required for entry.
Once the service is configured, it must then be assigned to the device. On the Phone Configuration sub-menu, go to: "Subscribe/Unsubscribe Services > Subscribe a New Service", you should then see the newly configured fast dial phone service in the drop-down box. As you will see, a user is directly tied to these services. The entries you make for the user here must match exactly to the entries made for them in the User Profile menu, otherwise the feature will give an error when it is accessed. Good luck.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...