Recieved a complaint that when an Admin attempted to answer a call for her boss she couldn't pick up the call and niether could the Boss or the other Admin that had the line on her phone. There was a message on the screen of the phone that stated ERROR PASS LIMIT. Any ideas?
It is currently set to 2/1 because we have calls roll to a 2nd line partition. Users have multiple buttons on thier phone of thier line. Plus I am not sure this may be the cause because no one else was on the phone at the time of this issue.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.