In installation of 4.1(3)sr2 in 4.1(3) Cisco CallManager I have seen the following errors:
* InsertCDR.exe - Application Error: The instruction at "0x102cd707" referenced memory at "0x00000000". The memory could not be "read". Click on OK to terminate the program. (IN PUBLISHER - INSTALLATION CONTINUES)
* DBAccess Failure: Attempt to access the database has failed. Collect c:\install\dbinstall\dbinstall00x.txt for diagnosis.(IN SUBSCRIBER - INSTALLATION STOP. LAUNCHING THE .EXE AGAIN, WORKING...)
Everything seems to be working properly, but customer is worried about the messages. Anybody has had the same problem?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.