I've AS5350 GW configured to T.37 and T.38. In the document http://www.cisco.com/en/US/products/sw/iosswrel/ps1830/products_feature_guide09186a0080087adb.html it is mentioned that it is possible to send xact command and as the answer on this command you'll have the entire statistic about the message witch is very convenient for us. Ive did as it was written and it was ok when you do it. My question is how it is possible to receive this information automatically? The problem is that the email server who sends the emails to this fax gateway doesnt support this command. How is it possible to get this statistic in this way?
And one more question concerning the command:
Is it standard esmtp command or no? If yes is it possible to provide me with the link on the document which is proving that.
From the link you sent, it says "The responsibility of delivering the fax-mail message falls to SMTP and the mail server." Also, "You need not configure any commands on the Cisco AS5300 to enable ESMTP accounting."... so I would take a look at the MTA and be sure it's set up correctly.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...