When you have failover in a Ex2000 cluster. Does the failover server Unity services such as AvMgr etc etc need to run under the primary server UNITY_servername acount or the one it created when you run the configuration tool?
Primary Server UNITY_servername1 account
Failover Server UNITY_servername2 account
The reason I ask this is that the AvMgr service is refusing to start on the failover server.
Run the AvCsMgr, AvCsGateway, AvUmrSyncSvr, AvGaen (and AvMsgStoreMonitor if this is 3.1.5) as the UNITY_servername1 account. I think the UNITY_servername2 that was initially created when the failover server was installed, has been deleted upon running the Failover wizard. The account created during the wizard is actually for the NodeManager service.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...