I am getting the above error when trying to run the Unity Configuration wizard. This is a new install of Unity 3.1(4). I have verified the group does exist. Any ideas would be helpful. I have checked all permissions etc.. I have never seen this error before.
Yeah, we've seen that error message before - it's usually a red herring - it is likely a DNS or DHCP issue. I'm betting the message included the unity server name as the domain (i.e. :"The Exchange Domain Servers Group could not be found in the following domain"\\UNITY"...) - that's the giveaway that this doesn't have anything to do with the actual Exchange Domain Servers group.
This could mean you have the Unity box configured to get an IP address from a DHCP server an none was found or there's a DNS name resolution issue at play...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...