the Exchange system tools and AD users and Computers do not verify that exchange is running on the box. as was previously suggested look in the services mmc and see if you see microsoft exchange services running. or if you know the name of the computer you can open exchnage system manager and see if the corresponding computer name is listed as an exchange server.(command prompt "hostname") since it would be innappropriate for the cisco guys on this forum to say this let me say it. If you are having this much of a problem identifying whether the box you are logged on to is an exchange server it is unlikely that you will be of much assistance when needing to configure it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...