Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Extension Mobility with CUCM 6.0

Hi,

We are finding a problem when configuring Extension Mobility with CUCM 6.0. When the configuration is completed, the phone will not reset, until we reset the Call Manager Service. We have applied the path 1a, has anyone else tried this/seen this problem.

cheers

Colin

6 REPLIES
New Member

Re: Extension Mobility with CUCM 6.0

New Member

Re: Extension Mobility with CUCM 6.0

That URL says it is fixed in the following releases:

Fixed-In

6.1(0.9901.348)

6.0(1.2102.1)

I can not find this upgrade files on the software download page:

http://www.cisco.com/cgi-bin/tablebuild.pl/callmgr-60

The latest patch available is: 6.0(1a)

As per the original poster (c.walsh) even applying the latest available patch - patch 6.0(1a) - does not solve the problem.

Where can I find the Fixed-In patches please? 6.1(0.9901.348) 6.0(1.2102.1)

Thanks

Mohan

Hall of Fame Super Red

Re: Extension Mobility with CUCM 6.0

Hi Mohan,

The latest CCM 6.x ES (Rollup includes 6.0(1.2102.1) is available here;

Cisco Unified Communications Manager 6.x ES

http://www.cisco.com/cgi-bin/tablebuild.pl/CUCM-ES6X

Hope this helps!

Rob

New Member

Re: Extension Mobility with CUCM 6.0

Oh OK. So it is an Engineering Special (ES). Let me try it.

Thanks Rob.

Mohan

Hall of Fame Super Red

Re: Extension Mobility with CUCM 6.0

Hi Mohan,

You are very welcome :) Make sure to take a few minutes to look at the ES Readme that is available as well.

Take care,

Rob

New Member

Re: Extension Mobility with CUCM 6.0

We since applied the patch "Cisco Unified Communications Manager 6.0 Device Package - Compatible CCM Version: 6.0(1)" at http://www.cisco.com/cgi-bin/tablebuild.pl/callmgr-60

Haven't been able to test it yet though. We didn't apply the ES, as in the readme for the ES,it said not to apply the ES it you are running a version less than 2701-1.

225
Views
5
Helpful
6
Replies
CreatePlease to create content