In a normal PABX , it is possible to have authorisation codes for long distance calls for each of the users or have extensions which has long distance calling restrictions and others not. Is it possible to have same on a Call manager ? The call manager version is 3.2
There isn't a way to really handle authorization codes in Call Manager today, this is supposed to be added in the next major realease. You can mimic the basic authorization code functionality but it's not very secure.
Create a route pattern that has a digit string for the authorization code. for example, a normal route pattern for long distance calls might be 9.@, you could create a route pattern say, 912345.@ where the 12345 is your authorization code. Not very secure and it could be difficult to bill.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...