Well it seems like all the usrs that were bulked from the initial install can log in and log out of the phones that i add the EM services to if they are enabled to under their user account (if that makes sense)
If i make a new user and enable EM then they cant login. i know that sounds weird
In adition to previus reply , dont forget to Subscribe The phones to the service , and in user page dont forget to associate EM to the user.
Another tricky part I usually see in my courses is that people resist to declare the url in ip phone services as it is presented. The url is case SenSitiVe and you should copy it as it is presented in configuration guides , excep of course the ip address of the CCM
Subscribing Cisco IP Phones to Cisco CallManager Extension Mobility
You must configure the Cisco IP Phones in Cisco CallManager before you subscribe the phones to Cisco CallManager Extension Mobility. To configure the phones, refer to the "Cisco IP Phone Configuration" section in the Cisco CallManager Administration Guide.
For a review of device profiles, refer to the "Understanding Device Profiles" section.
To subscribe to the Cisco CallManager Extension Mobility feature, perform the following procedure.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...