Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FAC & Tandem switching

CAllManager 4.1.3 Sr1 at main site. We have a remote site with Nortel opt11. connected to main site 3825 by PRI . That same 3825 has another PRI to PSTN. Both gateways are configured as MGCP. I am trying to implement FAC for international dialing. When I add a route pattern with out FAC it works fine but when I check FAC it fails . Error I get on deb isdn q931 is " No route to the destination"

However FAC works okay for phones at main site.

Are there any limitations on Tandem switching & FAC ?

1 REPLY
Silver

Re: FAC & Tandem switching

I think you are hitting CSCsb00532. There seems to be an issue with using FAC & MGCP.

106
Views
0
Helpful
1
Replies
CreatePlease to create content