Re: Fail save greeting after exporting from 2.46 to importing 4.
Problem 1 is that Unithy 4.0(1) doesn't support Exchange 2003 - assume you mistyped the Unity or Exchange version number there... you need to be at Exchange 2003 if you want to be running Exchange 2003.
The error numbers don't mean much without the event source and component (i.e. event numbers can be used over by different components) - when you get failsafe it'll alwasy log errors in the application event log - if you can post the full text of them it would be helfpul.
You should also run dbWalker (get the latest off www.CiscoUnityTools.com for your 4.0(x) system) - if there were problems in the DB after import they'll likely show up there and give us another clue.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.