I find that the while installing the SP1, the processing bar will go to about 100% finish and it will go back to 0%. it terminated without any error prompt and I find that event log stated that the Msi installation fail.
I tried the SP2 and got the same result. Also, I used the same installing account to apply the patch.
When you install the Service Pack, you need to have the service pack on your hard drive and execute it from there, with the original SQL/MSDE CD in the CD-ROM. The SP update needs the original .msi file from the CD to update..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...