3 Site WAN, Distributed CMs w/ PRI gateways, Centralized Unity Server:
Site A is a CM Cluster
Site B is a CM Cluster w/ Unity
Site C is a CM Cluster
Inbound calls to sites A and C route via ICTs to site B then to Unity Call Handlers. In the event either WAN link is down I want to route the call to an attendant DN. I know this is possible with VoIP dial peers using preference commands and translation patterns (but I had H323 issues with this), however I have the calls routing from the PSTN directly to the CM then across the ICT. Can this be accomplished in the CM?
PSTN>SITE A ROUTER>VOIP TO SITE A CM>ROUTE PATTERN MATCH TO ICT>SITE B CM>REDIRECT TO UNITY (this works flawless)
PSTN>SITE A ROUTER>VOIP TO SITE A CM>(WAN DOWN)>TRANSLATE TO LOCAL ATTENDANT DN>RING IP PHONE
Often times complex configuration & troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...