I need to create one list of speed dials for all IP phones in one remote site to share. I'd like to present this list to the IP phones as a service so that I can control which phones have access to this centralized speed dial listing. I'm not quite sure how Fast Dials is supposed to work and was curious if someone could point me in the right direction. I'm leaning away from personal speed dials so that it's not necessary for each user to maintain a separate listing.
This post is definitely a step in the right direction. (Thanks!) I've got a little homework to do, because it appears that the techs on that post were working with a windows-based call manager. I'm working with UCCM 6.1.2 on the Linux-based Appliance. I'm that most of the basic principles remain the same. I'll post my results.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...