Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Faststart, CNG and VAD

Hi,

By default H323 in CCM 3.2 will be in which mode? Faststart or Tunnelling?

How to switch from Faststart to tunneling mode?

Also how to enable CNG and VAD?

Regards,

Seetharaman.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Faststart, CNG and VAD

Most of these setting can be changed/toggled in Service -> Service Parameters (Select the appropriate server and the type of service). In your case you should select the primary CCM and select the CallManager Service.

VAD is indicated as Silence Suppression in the Service Parameters configuration

1 REPLY

Re: Faststart, CNG and VAD

Most of these setting can be changed/toggled in Service -> Service Parameters (Select the appropriate server and the type of service). In your case you should select the primary CCM and select the CallManager Service.

VAD is indicated as Silence Suppression in the Service Parameters configuration

140
Views
0
Helpful
1
Replies