Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Fax and the tone

Hi 

We are using interaction center(inin) for the fax service , there is no trunk created for fax numbers in cucm , users use their DN for faxes also , 

There are two problems facing now 

remote users are not hearing fax tone , i don't know the tone has to give by the  interaction center server or the gateway 

second problem  some analog users  especially (speed 2400 ) cannot send the faxes 

 

dial-peer voice 306 voip
 destination-pattern 'number'
 session protocol sipv2
 session target ipv4:10.0.1.1:5062
 dtmf-relay rtp-nte
 codec g711ulaw
 fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco
 no vad
!

 

Everyone's tags (1)
1 REPLY
VIP Super Bronze

Which vendor's equipment is

Which vendor's equipment is plugged into the PSTN circuit: Cisco or I3? If Cisco, are you using the fax TCL script or what is triggering the fax switchover? We need a better understanding of the design here. Perhaps put together a quick diagram.

 

49
Views
0
Helpful
1
Replies
CreatePlease to create content