How does the fax server listen for DTMF before listening for fax tone. The delay I have in adjusting when the switch outpulses DTMF is adj. but only @ 1.5 second increments, which is a rather large jump. I have tried both DTMF manual and DTMF telco, but the 1.5 second intervals that the switch will send DTMF happens either during Ringback or when the fax port has already answered and started fax tone. Is there a way to delay the onset of fax tone or wait until DTMF is rx or will the board still understand DTMF during fax tone? I can route faxes fine internally, i.e. I manually dial from another fax machine but DID faxing when the switch has to throw DTMF is where the problem comes in.<br><br>
Presumably you're using the old ActiveFax(LightningFax engine) on a 2.4 box with Dialogic GammaFax cards? If so, here's a post that talks about how to increase the wait time for DTMF digits coming in and related topics that should get your from A to B here:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.