Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Fax machine dialing from FXS without 9 in CCME

Hi everyone,

I have a fax machine connected to a FXS port (voice-port 0/1/0). We use the PRI for inbound and outbound calls (voice-port 0/0/0:23). I can currently make calls from the fax through the PRI but I have to dial 9. How can I not force the fax machine to dial 9?

Thanks!

Stephen

  • Other Collaboration Voice and Video Subjects
3 REPLIES

Re: Fax machine dialing from FXS without 9 in CCME

Is this a H323 or MGCP gateway ? If using H323

Use separate dial-peers for dialing from fax machines

dial-peer voice 1 pots

destination-pattern [2-9]...... (7 digit dialing in this case)

port 1/0/0:23

Then use COR so that phones wont have access to these dial-peers. Only fax machine ports should.

New Member

Re: Fax machine dialing from FXS without 9 in CCME

Thanks! Definatly steered me in the final direction. All works now!

Stephen

New Member

Re: Fax machine dialing from FXS without 9 in CCME

Go to the gateway configuration page on CM. Click on the appropriate gateway and view the fxs port you want to prepend the 9 on.

If you scroll down towards the bottom of the page there is a spot to put a prepend digit. Put a 9 in this field and reset the port. You should be good to go after that.

334
Views
4
Helpful
3
Replies