I have fax machines from Pitney and Ricoh behind a VG224. The Ricoh unit will intermittently not receive...it rings but does not pick up or fails handshake. The Pitney unit gives a fast busy signal. The Ricoh has been adjusted to begin communications at 9600, but the problems still exist. What can be adjusted in the VG224 to support the fax communication?
We have high volumes, usually 500 plus faxes per day. About every 2 weeks we get between 5 and 10 complaints of "incomplete" faxes. For instance: it should be a 10 page fax... we get 5 pages, but the sender does not get an error sheet. We are running CUCM 4.2(3).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.