cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
338
Views
0
Helpful
6
Replies

Fax over VG200 with mgcp

m.rueger
Level 1
Level 1

hi!

I want to use a VG200 (2x2 FXS) with mgcp for Fax. But the fax doesn`t work.

With a normal Phone (like a Siemens Gigaset) it works fine.

vy Markus

CallManager ver. 3.1(1)

VG200 (VG200-I6S-M), Version 12.2(2)T

-- something from sh run --

!

mgcp

mgcp call-agent xxx.xxx.xxx.xxx service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

no mgcp timer receive-rtcp

call rsvp-sync

!

ccm-manager mgcp

!

!

voice-port 1/0/0

cptone DE

!

voice-port 1/0/1

cptone DE

!

voice-port 1/1/0

cptone DE

!

voice-port 1/1/1

cptone DE

!

dial-peer voice 2 pots

application mgcpapp

port 1/0/1

!

dial-peer voice 1 pots

application mgcpapp

port 1/0/0

!

dial-peer voice 3 pots

application mgcpapp

port 1/1/1

!

!

-------------------------

6 Replies 6

dgoodwin
Cisco Employee
Cisco Employee

You need to use 12.1(5)XM4, and then add the command:

mgcp modem passthrough voip mode cisco

The exact parameters of the command may differ depending on versions, etc.

dave,

I have tried that IOS version on the VG200with the command:

mgcp modem passthrough voip mode cisco

Does this command prevent fax-relay from being used?

Still have problems with port lockups on the FXS ports. No dialtone from the device. Fast-busy when called from an IP phone. I have a doc from CEC which states that the functionality is not provided until 12.2(2)XN, for which the release date keeps slipping. If the fax machines being used request fax-relay, would the mgcp command have the effect of forcing a passthrough connection?

Pat

Hello,

Can I using VG200 FXS to Cisco1750 FXS .. use FAX function.

I can't do that, Can you give me some advice.

Shawn

FXS ports are used to connect end devices like phones or fax-machines. If you mean you have a fax connected to a FXS port on a VG200, then across a LAN or WAN you have a 1750 with an FXS port with a connected FAX, then yes. Need more details about the problem in order to help...

Pat

ccie6430
Level 1
Level 1

I had a problem with MGCP disconnecting the call just after the fax "tone" began. H.323 worked fine. I believe the code was .XM3

ptalbot
Level 1
Level 1

According to TAC, Faxing with mgcp on the VG200 is not supported until 12.2(2)XN which has yet to be released. Hopefully it will be released soon, the date has slipped several times. Until then, H.323 is the way to go. I have had very stable fax performance under H.323 on the VG200.

Pat

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: