When our vendor installed our system, they disabled Fax Relay on our 6608 gateways. Is there any reason for this? Has anyone had any problems with Fax Relay on a CCM 3.1.4b system w/ 6608 PRIs & VG248s?
Make sure you are ruinning with the latest dev pack for the 6608 and the latest code for the VG248 (1.2(1)). Fax relay did have some issues with the gateways until recently, but in the latest loads fax relay should work fine.
Our faxes did not work at all or consistently until fax relay was disabled. We use the 6608 and VG248 but we are on CCM 3.3. I am not the guy to answer this technically; our vendor discovered this solution after our cutover and faxes were still not working correctly, if at all.
Think of fax-relay as a very efficient method for transporting faxes _within_ a network domain ... one fax machine in LA attached via some gateway (6608, etc), sent across the network to NY, where another fax machine waits, attached to a gatway also programmed with fax-relay ... this fax call would perform quite well ... the reason you need fax passthrough (or to disable fax relay) is that the "other" fax machine to which you are attaching is across the PSTN network, which is out of your network domain and thus more than likely does not understand the fax-relay configuration ...
I had problems with setting up faxing using CCM 3.1.4, a VG-248, and an HDV module in a 3640 ... it was is part due to the code release on the VG-248 (since upgraded to 1.2.1) and the code revision on the gateway ... it can be solved though!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...