Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FAX releay

Hello

we have a Catalyst 6509 with a WS-X6624, 24 port FXS module installed. On the ports where we have fax machines connected we configured the call restart timer to fax relay (1235). With this configuration we are not able to send some faxes to remote fax machines. On the local fax we can see always an interruption. If configure the call restart timer back to the default settings (5000) we have not that problem on the same remote site but then other remote sites will not working. Is there somebody who can give me a hint?

Thanks,

Rlolf

  • Other Collaboration Voice and Video Subjects
1 REPLY

Re: FAX releay

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

119
Views
0
Helpful
1
Replies