Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

fax server using the pstn router

Hi, we are actually looking for a new fax solution since the implantation for our Cisco ip phone, and what I want is a fax system that use no analog card, something that can use my ISR 2811 as a fax gateway. This 2811 actually have a PRI.

I'm running CCM4.1(3), Unity 4.0(5), Exchange 2003 and the lastest IOS version on my 2811.

Thanks !

1 REPLY

Re: fax server using the pstn router

The following is a link to the supported fax server software for use with Unity 4.0/4.1.

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_system_requirements_hardware09186a0080531f2a.html#wp32264

Different software supports different fax cards. You could use an analog card to connect to an ATA or FXS port which would then route calls out your PRI. You could also use a digital card in the fax server to handle a dedicated PRI for fax.

Hope this helps. If so, please rate the post.

Brandon

109
Views
3
Helpful
1
Replies
CreatePlease to create content