fax server using the pstn router

[francis.labelle]

Hi, we are actually looking for a new fax solution since the implantation for our Cisco ip phone, and what I want is a fax system that use no analog card, something that can use my ISR 2811 as a fax gateway. This 2811 actually have a PRI.

I'm running CCM4.1(3), Unity 4.0(5), Exchange 2003 and the lastest IOS version on my 2811.

Thanks !

[Brandon Buffin]

The following is a link to the supported fax server software for use with Unity 4.0/4.1.

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_system_requirements_hardware09186a0080531f2a.html#wp32264

Different software supports different fax cards. You could use an analog card to connect to an ATA or FXS port which would then route calls out your PRI. You could also use a digital card in the fax server to handle a dedicated PRI for fax.

Hope this helps. If so, please rate the post.

Brandon