Fax timeout when trying to establish an international call
We have installed CCM 3.3(2) and a VG248 for analog connections. An international call lasts 25 seconds till you receive the ringback tone (a national call is inmedately established). This happens from any IP phone. The problem is that the faxes connected to the VG248 cannot make an international call (no problem with national calls), and we think that it is because there is a timeout that aborts the connection.
Re: Fax timeout when trying to establish an international call
We experienced the same problem during our install took a couple days to solve but now owrks great. We found that the problem seemed to occur more when using the same type of fax machine on each side and they transmitted at a higher speed. In the end the problem was solved by installing the latest at the time - vg248 ios and changing some setting.
Here is what we have software 1.2(1) and dsp 3.6(20x)
Fax relay enabled on call manager gateway port. Default settings for speed, relay etc on vg248.
Feel free to email me if you would like to compare settings.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.