We have a PRI being terminated on a Dialogic card. The PRI will have a couple hundred DID lines. Half of these are suppose to be for fax. How do we route the faxes to the fax server so they can be sent to Unity/Exchange. Does Call Mgr have to send the faxes to a Cisco router and have analog ports off of it connecting to the fax card on the fax server? Do we use DTMF signling to get the digits to the fax card and on to the fax software?<br><br>Any details for such a solution would be valuable.<br><br>Thanks<br><br>
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...