Does anyone have a good configuration for setting up the vg248 and ata186 with 2651XM gateway using a PRI. I have turned off fax relay on the vg248. The faxes will start to go out but then get disconnected. I am running CCM 3.3(2). The 2651 is setup as an MGCP gateway.
If you turned fax relay off on the vg248, make sure that the relay is also turned off accross the board, i.e. it should be turned off on your gateway as well. if it is an h323 gateway, just go to the dial peer for your voice and do it there, if you have an mgcp such as a 6608, then you should uncheck the fax parameters like ECM enable and fax relay enable. that shoudl take care of it. On ATA's, go to its config page by /dev and change the audio mode to 0x0000012 (not sure how many zeros though), try it and should work.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...