I have a 3640 with 12.2XB6. I have a t1 line coming into the router. I want to configure Store and Forward Faxing can this be done? What I would liket to accomplish is the following: A FAX comes in on the t1. It goes to a MMOIP dial peer which then sends the FAX to a mail address. I have configured the dial peers then send a fax to a number, which is $d$ for the user. In exchange the user has an alias of xxxx, which is the number. No matter what I do the MMOIP dial peer never gets initiated. I confirm this by issuing the command debug voice ccapi inout. I know the dial peers are set up correctly. Is there something I am forgetting? If anyone can help I would appreciate it. Thanks in advance.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...