Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

Filter base on CallerID to VM for only 1 User

Hi

CM4.0.2sr2a - Can I Filter base on CallerID to VM for only 1 User.

Reason: This user gets constant sales calls from certain vendor that they recognize the callerID and don't want to answer their calls but rather have it go to VM

  • Other Collaboration Voice and Video Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Filter base on CallerID to VM for only 1 User

perhaps you can setup a phone template that has an "idivert" button where if the user sees an incoming number they don't want to answer, they can just press the 'idivert' button and the call goes straight to voice mail.

see the following link for more info:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ed115.html

1 REPLY
Blue

Re: Filter base on CallerID to VM for only 1 User

perhaps you can setup a phone template that has an "idivert" button where if the user sees an incoming number they don't want to answer, they can just press the 'idivert' button and the call goes straight to voice mail.

see the following link for more info:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ed115.html

104
Views
0
Helpful
1
Replies
This widget could not be displayed.