I am attempting to implement RightFax Server FOIP ( TR1034+P30H-E1 ) with Cisco IP Telephony , our customer asking me if we can make a cisco router route the incoming fax to another fxs port - ATA - fax machine in case rightfax is down for backup solution. ??
What type of fax relay is supported by the Right fax card ?
i assume t38.
So you may have a voip dial-peer with t38 enabled for the fax DIDs pointing back to fax server ? If yes you can try configuring a POTS dial-peer with the same destination-pattern, map the FXS port where the fax machine is and use a preference of 1. Default dial-peer preference is 0. So voip dial-peer will always be used and fax will go to rightfax server. If the voip dial-peer gets a busy, it should hunt to the pots dial-peer and all fax should receive on the analog fax machine.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.