Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Force a call to use a specific channel

Does anyone know how I can force a voice call to go through a specific channel on a T1 running CAS and E&M?

I could rebuild the ds0-group to only have that channel but I would rather not do that. Any other ideas?

2 REPLIES
New Member

Re: Force a call to use a specific channel

You can achieve this by using trunk groups. Refer to this URL for more details.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00800b5dbf.html#xtocid2

Cisco Employee

Re: Force a call to use a specific channel

The trunk group is used to group interfaces. Not split them up. If you have T1 CAS you have to build separate DS0 groups to create separate voice-ports. This will allow you to route to specific channels.

114
Views
0
Helpful
2
Replies