Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Force fxo to dial from speecific ports

I have 2 vg200 with 2 2vic-fxo-m1 cards in each. this is for a test environment. I want 8 different phones to use their own line and their own line only to dial out. i have an h323 gateway set up. For incoming calls, i have the gateway set up to go to the appropriate phones but cant get the other way around to work. Any help would be appreciated

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: Force fxo to dial from speecific ports

You will need to create a partition/Search Space for each phone. Then you can configure a route pattern/route list in each partition that prefixes some access code like "12". On the gateway, configure your dial peers with destination pattern matching on 12 (destination-pattern 12.......) The gateway will then discard the destination pattern and send the remainder to the port you specify.

Hope that helps

New Member

Re: Force fxo to dial from speecific ports

ouch, thats brutal

94
Views
0
Helpful
2
Replies