I am getting a VOIP (SIP based) T1 from my service provider and a number is routed to this T1. I want to have a box (router)where i can termiate this T1 in my office and this box (router)shouled forward the incoming calls on this T1 to another office where I have AS5350 gateway which will route the calls to its ultimate destination which is SIP based IP phone.
The recomended box (router) and AS5350 in the other office will be connected through a IP network.
SIP subscribers do not hear a final dial tone upon completing activation or deactivation. Instead, an announcement plays for the subscriber, indicating that the status of the forwarding feature is being activated or deactivated. This is irrespective of the Final Stage Dial Tone (FDT) flag (Y/N) provisioned for these features.
Call Forwarding to an E.164 Number or an Extension Number
In Release 4.1, activation is accomplished using single-stage dialing. This applies to all activation and deactivation.
Calling Name and Number Delivery
Calling number delivery (CND) provides the SIP subscriber endpoint with the date, time, and calling number in an incoming call. When the called subscriber line is on hook, the calling party information is delivered during the long silent interval of the first ringing cycle. Telcordia document GR-30-CORE specifies the generic requirements for transmitting asynchronous voice band data to the SIP subscriber line.
For more information, refer to the Calling Name Delivery section in the Cisco BTS 10200 Softswitch System Description guide.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...