05-08-2002 02:24 PM - edited 03-12-2019 06:44 PM
I would like to know if there is a way to strip off digits on a Vofr call. I know that with VoFR dial peers, the digits are forwarded by default. But what I am trying to do is get a second dial tone across a VoFR connection.
Thanks
Mike
05-14-2002 02:18 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
05-14-2002 02:27 PM
Use translation rule. Do a search on cisco.com for translation-rule and there are some examples. To strip or change digits on the IP or FR leg of the call you need to translate them.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: