Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FR QoS and LFI, which interface the bandwidth command?

I want to configure LFI in the Frame-relay network and have a question where do I need to configure the bandwidth command.

The physical bandwidth is T1 and the desired is 512Kbps to QoS calculation. Do I need configure on the FR subinterface and virtual-template1 both or virtual-template1 only?

int s0/0

enc frame-relay

frame-realy traffic-shaping

!

int s0/0.100 point-to-point

frame-relay interface-dlci 100 ppp virtual-template1

class FRTS

!

int virtual-template1

ip add x.x.x.x

service-policy output xxx

ppp multilink

ppp multilink fragmentation delay x

ppp multilink interleave

Thanks in advance,

1 REPLY

Re: FR QoS and LFI, which interface the bandwidth command?

I believe if you set it on int virtual-template that will suffice, as Ive seen configuration like:

interface virtual-template 1

ppp multilink

encapsulated ppp

ppp multlink interleave

ppp multilink fragment-delay 20

ip rtp reserve 16384 100

HTH,

Vlad

113
Views
0
Helpful
1
Replies