I have a 2811 (with a PVDM2-16, VIC2-4FXO, and an NM-HDA (4FXS, 4FXO, and 4FXO)) and want to use the PVDM for a Conf Bridge.
I'm not using the VIC2 for anything but it keeps grabbing the PVDM2's DSP and I am unable to free it up for a conference Bridge. I tried to shut down all the ports on the VIC2, but the DSPS still get assigned. Short of pulling the VIC2 out of the router, is there any way to disable the VIC2 so it doesn't take the dsps?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.