I have an existing IP Telephony remote site with a PRI running MGCP and a centralized CM in the home office. We have an analog line coming from the PSTN that we are going to attach via a FXO port on a 3640 router that we want to send to the CM and let that number show up on a shared line for 2 IP phones. I need help understanding how to get the call from the FXO to CM to IP phones. This line will only have to receive calls and not send out, the outbound calls will be processed like the existing outbound calls at this site. I was also thinking about translating the number coming in to a 4-digit number that matches the current dial pplan in this remote site. Thanks for your help!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...