Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO dial out problem

I am running CME, I have 2 analogue exchange lines connected to my FXO ports, I need my IP phones to dial out on particular exchange line, not just pick the one that is free. I have tried the answer-address statement on the dial-peer, but it still alternates between the 2 lines.

Any suggestions ???

1 REPLY
New Member

Re: FXO dial out problem

I would configure 2 different access codes for dial out.That way, you can use your dial peers to point to a specific port based on the access code dialed. For example:

dial-peer voice 1 pots

destination pattern 8T

port 1/0

dial-peer voice 2 pots

destination-pattern 9T

port 1/1

That's a quick and dirty fix.

103
Views
0
Helpful
1
Replies
CreatePlease login to create content