Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FXO disconnect problem

hello

i have put these commands in my FXO configuration:

timeouts call-disconnect 3

timeouts wait-release 5

timing percentbreak 60

timing guard-out 300

bearer-cap Speech

supervisory disconnect dualtone mid-call

supervisory answer dualtone

pre-dial-delay 2

signal groundStart

but still after a call the line is busy and fxo is off hook for a long time

what can i do next?

1 REPLY
Silver

Re: FXO disconnect problem

If you can figure out the frequneices of the busy tone being played by your telco/pbx you can sue this document to configure the router to drop the call if it hears a tone on that frequency

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1834/products_feature_guide09186a00801601ac.html

ALternatively you could purchase an M1 card whcih has support for battery reversal.

204
Views
0
Helpful
1
Replies
CreatePlease to create content