Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FXO doesn't detect busy signal after transfer

If I'm calling on voice-port, it will pickup give me dialtone, press internal number then hangup on my side. Extension will call about 2 minutes

It's seems it doesn't monitor line in transfer, because if I do enable connection plar opx, its will stop calling almost immediately after far end hangup

here is part of my config:

voice-port 0/2/0

translation-profile outgoing moscow

supervisory disconnect dualtone mid-call

supervisory answer dualtone

supervisory custom-cptone PSTN

supervisory dualtone-detect-params 1

no battery-reversal

cptone RU

timeouts call-disconnect 1

timeouts wait-release 1

description 264-09-96

caller-id enable

3 REPLIES
Silver

Re: FXO doesn't detect busy signal after transfer

Could lyou provide the detials of

sh call active voice,

debug voip ccapi inout.

debug vpm signal

New Member

Re: FXO doesn't detect busy signal after transfer

here is both debugs enabled and sh call active voice.

New Member

Re: FXO doesn't detect busy signal after transfer

In this case call cumming to FXO and transferred to another FXO.

178
Views
0
Helpful
3
Replies
CreatePlease to create content