FXO - MGCP using 2811 Router

[admin_2]

I have configured 4 FXO (LS) on a 2811 router via MGCP gateway to the CCM.

Problem: When I disconnect the far end the Cisco IP phone stays connected. Is there a setting I can put on the voice port in the router or CM to disconnect when the far end disconnects.

Thanks!

joe

[thisisshanky]

Joe this may help!

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

Sankar

PS: please remember to rate posts!