Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FXO port config for an H323 gateway using CCM 4.2

Hi,

I'm configuring a 2811 gateway using H323 that has 4 x PSTN lines which carries the same DDI number. This will then use call manager to distribute the call to an end user phone.

Firstly - do I need to configure the FXO ports as a plar connection with the DDI number?

Secondly - for an outbound dial peer, will I have to give all of my destination patterns 4 preferences as to which voice-port to use??

Regards

Dave

2 REPLIES
Green

Re: FXO port config for an H323 gateway using CCM 4.2

1.Correct, configure the plar under voice-port then your VOIP dial-peers.

2. You can do it and I would say it is a best practice.

New Member

Re: FXO port config for an H323 gateway using CCM 4.2

Thanks for the response. Do I need to configure it as connection plar or connection plar opx??

Cheers

Dave

277
Views
3
Helpful
2
Replies
CreatePlease to create content