Not sure about CME, but in a gateway if you want to have it accept inbound calls to a specific number you need to set the voice-port up with a PLAR number if an H323 gateway, or AutoAttendant number in the gateways MGCP configuration in CM if using MGCP.
Or if you want to you and you don't configure this, then when someones dials, the FXO port will answer then present a second dial-tone to the caller, whereupon the caller will have to dial an ext number in to call an ext. Its called 2 stage dialling.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...